How Much Does Spray Foam Insulation Cost in Enterprise?
Spray foam insulation in Enterprise typically runs $1,100 to $2,400 for a standard attic (open-cell, 1,000 to 1,500 sq ft), or roughly $1.50 to $4.00 per square foot installed depending on foam type and thickness. A full open-cell attic job lands in the $1.10 to $2.25 per board foot range, while closed-cell foam runs higher, at about $1.75 to $4.00 per board foot. Homes with smaller crawlspaces or rim-joist work often come in under $900.
We’ve put the real Enterprise numbers below so you can walk into your estimate already knowing what’s fair, what drives the price, and where a quote is too low to be honest.
Spray Foam Insulation Cost Breakdown (2026)
Here’s how spray foam pricing shakes out in the Enterprise market this year. These are installed ranges that include prep, application, and cleanup. Every homeowner we work with gets a written price before a single can is opened.
| Job / Application | Typical 2026 Price Range | Notes |
|---|---|---|
| Open-cell spray foam, attic (per board foot) | $1.10 – $2.25 | Softer foam, good for sound dampening and air sealing |
| Closed-cell spray foam (per board foot) | $1.75 – $4.00 | Higher R-value per inch, adds a vapor barrier |
| Standard attic, 1,000 – 1,500 sq ft (open-cell) | $1,100 – $2,400 | Most common residential job in Enterprise |
| Rim joist / band joist sealing | $450 – $900 | Common on homes with vented crawlspaces |
| Crawlspace encapsulation with closed-cell | $1,800 – $4,500 | Depends on square footage and moisture conditions |
| Exterior wall cavity (per sq ft) | $1.50 – $3.50 | More labor-intensive; sometimes blended with other work |
| Minimum service call / small spot jobs | $350 – $650 | Small patches, penetration sealing, rim gaps |
What pushes a job toward the top of those ranges: closed-cell instead of open-cell, thicker application for a higher R-value, hard-to-reach framing, or a home that needs old insulation removed first. What keeps it lower: a straightforward open attic, easy access, and bundling the spray foam with an attic insulation or air-sealing job done the same day.
One thing that surprises a lot of Enterprise homeowners: closed-cell costs nearly double open-cell per board foot, but because it delivers a higher R-value per inch, you sometimes need less of it. On a shallow attic, closed-cell can actually come in close to open-cell on the total. We’ll show you both numbers side by side so the tradeoff is clear.
What Affects Spray Foam Insulation Pricing in Enterprise
Enterprise sits in the high desert south of Las Vegas, and that climate shapes the work in ways a generic price chart won’t tell you. Here are the six factors that move your quote the most.
- Foam type and R-value target. Open-cell foam gives you roughly R-3.5 to R-3.7 per inch; closed-cell gives you around R-6 to R-7 per inch. Wanting a higher R-value means more foam, and more foam means a higher price. We match the product to your attic, not the other way around.
- Attic condition and access. A clean, open attic with a wide hatch is fast to work in. A low-pitch roof, tight scuttle, or attic full of stored boxes slows everything down. Labor is a big part of the bill, so access matters more than most people expect.
- Old insulation removal. If there’s existing fiberglass or blown-in material in the way, it usually has to come out before foam goes in. Removal and disposal add to the total.
- Climate and sun exposure. Enterprise summers push attic temperatures well past 140°F, and the intense UV and dry heat break down some older insulation faster than homeowners realize. A foam job that seals the attic against that heat often pays back quicker here than in milder climates, which is worth factoring into how you think about the cost.
- Square footage and geometry. Straight runs are cheaper than a roof with lots of valleys, dormers, and knee walls. We measure the actual surface area, not just the floor plan, because that’s what determines how much foam you need.
- Bundling with other work. Pairing spray foam with attic insulation or air sealing in one visit spreads the labor and often lowers your per-square-foot cost. It also means one crew, one written price, one clean job.
If you want to see how spray foam fits next to the other products we install, our Spray Foam Insulation in Enterprise page walks through where it makes sense and where blown-in does the job for less.
Open-Cell vs. Closed-Cell: Which Costs More, and When Is It Worth It?
Closed-cell foam costs more up front but does more. It seals as a vapor barrier, adds structural rigidity, and packs a higher R-value into every inch. Open-cell costs less, expands more, and softens sound, which makes it a good fit for interior walls and open attic floors where depth isn’t a problem.
For an Enterprise attic baking under the summer sun, closed-cell is often the smarter long-term pick on the roof deck. For a vented attic floor where you’ve got room to build depth, open-cell usually wins on price without giving up much performance. We’ll tell you which one your specific attic calls for, with the reasoning and the price for both, before you decide.
How to Save on Spray Foam Insulation
There’s no magic discount, but there are real ways to keep the number down without cutting corners on the foam itself.
- Bundle the job. Combining spray foam with air sealing or attic insulation in one visit shares the labor and typically beats two separate appointments on price.
- Fix air leaks at the same time. Sealing gaps around can lights, top plates, and penetrations before foam goes down means the foam goes where it counts. You’re not paying for coverage over a leak that’s still leaking.
- Choose the right foam for the space. Open-cell in the attic floor where depth allows, closed-cell only where it earns its cost. Paying for closed-cell everywhere is often money you don’t need to spend.
- Clear the attic ahead of time. Moving stored boxes and clearing the hatch yourself saves the crew setup time, and that shows up in your quote.
- Get the written price first. An honest quote is a fixed number, not a range that creeps up. Ask for it in writing before any work starts, and compare apples to apples. We deliver one on every job, no exceptions.
Wondering what a fair number looks like for your home? Call (844) 761-9996 for a free estimate. We’ll measure your attic, show you the open-cell and closed-cell numbers, and put the price in writing before anyone touches a hose.
What Does Spray Foam Insulation Include?
A proper spray foam job is more than pointing a gun at the ceiling. Here’s what a full-service install covers, and what you should expect on the invoice.
- Attic assessment. We check existing insulation, air leaks, moisture, and access before quoting.
- Prep and protection. Covering living space below, masking surfaces, and setting up ventilation.
- Application. Foam sprayed to the agreed thickness, measured, and trimmed where needed.
- Cleanup and walkthrough. Hauling out debris and walking you through what was done.
- A written price before work begins, and the 365-Day Done Right Promise covering labor and materials for a full year. If something fails, we come back. If a repair doesn’t hold, the second visit is free.
How Long Does Spray Foam Last, and Does That Change the Math?
Spray foam holds up for decades when it’s installed right, so the per-year cost of the job is far lower than the sticker price suggests. A $1,800 attic job that lasts 25 years works out to roughly $72 a year, before you count the energy savings from sealing the attic against Enterprise heat. That’s the honest way to compare it to lower-cost options that may need replacing sooner. We’ll break down the per-year math for your home on the estimate so you can see the real cost, not just the up-front number.
Why Enterprise Homeowners Choose Us for Spray Foam
The price is only half of what makes a job worth doing. The other half is knowing who’s doing it and what happens if something goes wrong.
- Written price before work starts. Every homeowner gets the number in writing first. No post-job surprises, no line items that appear after the fact.
- You know who’s coming. Every technician is background-checked, identity-verified, arrives in a clean marked uniform, and shows a photo ID badge at the door. We send the tech’s name and photo before the visit. If someone else shows up, the visit is free and we make it right.
- A live person answers, 24/7. No voicemail loops, no call-back windows. When you call, a person picks up.
- The Threshold Standard. Our verification and conduct expectations come from the Threshold Verified standard, and each location is independently owned and operated under that bar.
- 365-Day Done Right Promise. Written on every job, covering what we install. If it fails, we come back, and if a repair fails, the second visit is free.
- The right material for the job. We source from Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demelec, and GreenFiber, and match the product to your attic rather than pushing whatever’s on hand. Our technicians have up to 24 years of experience.
We’re part of the Threshold Group family, and every job carries the same written price and written guarantee. If you want to understand the broader picture of what insulation work looks like in town, start from our home page.
How Does Spray Foam Compare to Blown-In on Price?
Blown-in insulation (loose fibers blown into the attic cavity to fill every gap) usually costs less up front than spray foam, often in the $1.00 to $2.50 per square foot range installed for a standard attic. Spray foam costs more but seals air leaks and adds structural performance that loose fill alone doesn’t. On a vented attic floor with plenty of depth, blown-in is often the smarter spend. On a roof deck, a steep-slope vaulted ceiling, or anywhere air sealing matters, spray foam earns its higher price. We install all three of our core services, so the recommendation follows your attic, not a sales target. For side-by-side pricing on all three, call (844) 761-9996.
FAQs – Spray Foam Insulation Cost
How much does spray foam insulation cost in Enterprise?
Spray foam insulation in Enterprise runs about $1.10 to $2.25 per board foot for open-cell and $1.75 to $4.00 per board foot for closed-cell in 2026. A typical 1,000 to 1,500 sq ft attic lands between $1,100 and $2,400 installed. Small spot jobs and rim-joist sealing often fall between $350 and $900. Call (844) 761-9996 for an exact quote, free of charge.
Is spray foam worth the extra cost over blown-in?
It often is when air sealing matters or you’re insulating a roof deck. Spray foam seals leaks and delivers more R-value per inch than loose fill. On a deep, open attic floor where airflow isn’t the issue, blown-in can do the job for less. The honest answer depends on your attic, and we’ll show you both numbers before you decide. Call (844) 761-9996 for a free side-by-side estimate.
What’s the cheapest way to insulate an attic in Enterprise?
Blown-in insulation on a vented attic floor is usually the lowest-cost route, typically starting around $1.00 per square foot installed. Pairing it with air sealing keeps the savings from leaking away. If you want the least expensive option that still performs, that’s the combination. Call (844) 761-9996 and we’ll price it for your attic.
Does spray foam insulation actually lower energy bills in Enterprise?
It usually does, and the effect is noticeable in Enterprise’s high-desert summers. Sealing the attic against 140°F-plus attic heat cuts the load on your AC and reduces the swing in room temperatures. The exact savings depend on your home, your HVAC, and how leaky your attic is now. We’ll walk you through the likely impact at the estimate. Call (844) 761-9996 with your address to get started.
Can you come out and quote my attic this week?
Yes. Estimates are free, and we deliver a written price before any work begins. A live person answers the phone 24/7, so you can call anytime and get on the schedule. Call (844) 761-9996 and we’ll set a time that works for you.
Get Your Written Price Before the Work Starts
You shouldn’t have to guess what spray foam will cost, and you shouldn’t have to let a stranger into your attic without knowing who they are. We put the price in writing, we send the technician’s name and photo before the visit, and we back the work with the 365-Day Done Right Promise. Estimates are free, and a live person answers when you call.
Call (844) 761-9996 for a free estimate on spray foam insulation in Enterprise. We’ll measure your attic, show you the numbers for both foam types, and put the price in writing before anything starts.
Written by the team at Aspen Attic Insulation.
Pricing reflects the Enterprise market as of 2026. Aspen Attic Insulation Enterprise offers free estimates – call (844) 761-9996.
What Our Customers Say
"The estimate was clear on R-value and cost per square foot. No add-ons."
- Omar N."Blown in cellulose up to R-49 in the attic. Tech badged in at the door and measured the depth with a ruler before and after. Upstairs bedrooms stopped being an oven."
- Fran T."Vetted crew, which I liked. Installed baffles at the eaves so the vents stay clear."
- Sonia B.